The simplest way would be to use a program such as puTTY in place of the Arduino Serial Monitor. PuTTY can save data into a file. You could also write a program on your PC to receive the data and save it into a file.
Posted by3 years ago
Archived
Has anyone been successful in using PuTTY to talk to a serial port on Windows 10?
Whenever I try, it just beeps at me. I'm using 8/N/1. I tried all the flow control options and various baud rates.
![]()
The Arduino IDE will talk to my devices, so it's not drivers or the device I have connected and I know I'm using the correct COM port and baud rate.
Edit:
2006 Range Rover Sport Supercharged Owners Manual PDF Online Free is full of good knowledge and reference. 2006 Range Rover Sport Supercharged Owners Manual PDF Online Free2006 Range Rover Sport Supercharged Owners Manual PDF Online Free bring the positive think in the future? Reading 2006 Range Rover Sport Supercharged Owners Manual PDF Online Free can be disappeared the readers stress with the daily routine.It makes the readers become relax and fresh.How to get 2006 Range Rover Sport Supercharged Owners Manual PDF Online Free? It makes the readers have good and much knowledge. Range rover sport owners manual.
Ok, I figured it out. I was clicking Serial in the left hand panel. Apparently, that was not for opening a connection to a serial port, but for setting up the default options for serial connections.
There is an 'Open' button on that screen, but if you click on that it just beeps at you.
Apparently what I should have been doing was clicking the Serial radio button under Connection Type: on the Session screen.
6 comments
Active3 years, 7 months ago
Need putty to work on
/dev/ttyUSB0
I know for a fact that the port (console on a switch) is 9600 8/n/1, so it should be simple.
ttyUSB0 shows up in dmesg.
So shouldn't I be able to select
/dev/ttyUSB0 in putty's serial configuration and it should work.
Putty Serial Monitor Reviews
Works fine when I'm running putty with windows.Doesn't work with Ubuntu/putty. I get no response.
This is how I started it:
Any suggestions?
ScottScott
2 Answershg8
10.4k1212 gold badges5959 silver badges9494 bronze badges
lhifnirlhifnir
I use minicom.To install
minicom use command
Start minicom setup with command
You will get setup menu
go to
Serial port setup
Change
Serial Device
![]()
Change
Bps/Par/Bits
After changes hit Enter
Save setings
Go to
Exit to exit from setup in minicom
You minicom is ready
27079742707974
8,46666 gold badges2323 silver badges4040 bronze badges
Not the answer you're looking for? Browse other questions tagged usbputty or ask your own question.Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |